Previous: Syntax Errors, Up: Debugging [Contents][Index]
When an error happens during byte compilation, it is normally due to invalid syntax in the program you are compiling. The compiler prints a suitable error message in the ‘*Compile-Log*’ buffer, and then stops. The message may state a function name in which the error was found, or it may not. Either way, here is how to find out where in the file the error occurred.
What you should do is switch to the buffer ‘ *Compiler Input*’. (Note that the buffer name starts with a space, so it does not show up in M-x list-buffers.) This buffer contains the program being compiled, and point shows how far the byte compiler was able to read.
If the error was due to invalid Lisp syntax, point shows exactly where the invalid syntax was detected. The cause of the error is not necessarily near by! Use the techniques in the previous section to find the error.
If the error was detected while compiling a form that had been read successfully, then point is located at the end of the form. In this case, this technique cannot localize the error precisely, but can still show you which function to check.